Teddz77 Community Member
Joined: 10 Feb 2017 Posts: 12
|
Posted: Wed Aug 12, 2020 7:04 am Post subject: |
|
|
been a while since I updated, so here's the skinny...
I'm off for the month and will be wrapping things up.
After the first few lathe ops...
Left side: Roughly 56 Tomen barrels
Right Side: 10 Anders/Doran barrels
Center: 46 Tomen cylinders
Behind the WD-40: 1 Sidkit blank, 1 Brass Tomen wrapped in a paper towel to protect the finish and a random dud test piece I've blued.
For those wondering, the aluminum can skins in the upper right are used to protect the machined surface from marring and scratches when I chuck them back on the lathe after turning to the correct OD, drilling the mounting holes and then boring them out.
Slugs for 26 more tomen cylinders and 35 more barrels for the Anders/Doran PKD versions.
 |
|